Hi everyone!
I've installed the bushings and bearings in the HT and test installed it to the fuselage. I can't get the nose of the HT to go down as much as I've seen in other postings, and it doesn't go down enough to meet the trim jackscrew when fully retracted. The stab hinge mount interferes with the pivot mount. I've removed all the powdercoat. It looks like I need to either grind down the welds on the hinge mount, or grind out some clearance on the square pivot mount bracket. I've searched the forum for this problem but haven't found any posts mentioning this problem. Has anyone encountered this? Any suggestions? See pictures below.
Thanks.
IMG_5530.jpgIMG_5533.jpg