I have a laker leading edge, and when I covered and heated up the polyfiber to 350 degrees, I got a small ~1/16" deep x 1/2" wide x 4" max indent on the leading edge. It appears the laker leading edge may have been thin and collapsed in this area??? It is actually hard to see, but it is very easy to feel. It is also very solid (doesn't feel soft when you push on it).
My question is, what is the best procedure to fix? Can I fill this area and put the leading edge tape over it and call it good? If so, what filler should I use over the polyfiber cloth? Do I poly brush it first, or after the filler? Or do I need to remove all the covering, repair, and re-cover? It is still very strong and only is affecting aesthetics at this point.....
Thoughts? Thanks!