Grover,


Thanks for the heads up on the source for the solenoid



I am of the opinion that many parts sold by rotax at rather proud $ can be sourced other places.



1) I got the aux belt drive alternator. With the shiny new alternator sitting on my bench, I happened to glance over at a 1984 ND toyota pickup alternator sitting in my shop - yup - physically the same part - pulling the shell bolts and rotating the back end 90 degrees gave the same position for the terminals.


2) JerryTex on the list saved my bacon on an O-ring. I later found out that another company Airplane Builders are familiar with, McMaster-Carr, has metric O-rings and an on line guidance document outlining the application for Buna-N, Silicon and other O-ring material formulations. Plus they have O-ring material, including metric, in coils so a person can cut and bond specific O-rings for those really long casting seals.


3) Heat conductive paste which rotax sells for a tidy sum for a few drops has been covered on this list - products of an equivalent formulation in 5 oz tubes are available from Dow Corning 340 and others.



Repackaging/relabeling is a wonderful way to make money



Oh, and bolts.....Those of us with special interest cars become familiar (quickly) with Chryslers SAE wheel nuts that are right handed thread on one side and left handed thread on the other. Best to keep any millenial shop tech away from these with their air wrench.