Can't get in the mood to go play with Hysol, so I was going to drill the three holes in the Flaperon Reinforcing Brackets (Yes, left side only).



The construction manual says,"Drill the left side P/N 12041.101 brackets to the approximate locations shown."


The illustration has two holes .463" below the top surface, and the other is 1.188" below the surface. From the left side, the first hole is .438" in, and the other two holes are 1.375 and 3.250. "Approximate" and three decimal places is confusing to me.



Can I put the upper two holes 7/16" from the top (.4375) and the lower one

1 3/8" down? I am guessing I just need to get them in the vicinity of where the diagram shows, not necessarily 3 decimals.




Steve