Here is what I did. Used a 4-40 rod and Clovis from the hobby shop:
Here is what I did. Used a 4-40 rod and Clovis from the hobby shop:
-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
And another picture
-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
And another view:
-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
I have the Skyview system. I used the same on my RV-10. I'll check the wiring tomorrow.
-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
OK, thanks again.
Of what I understand is that the sensor has to connect to the EMS module and only has one wire for this purpose, the sensor has 3 (orange, green and blue ), my guess is the green one. Just want to be sure on this before I continue. Now I know the Ray Allen sensor can be used with the Skyview.
Leonardo
http://www.vansairforce.com/communit...p?t-69494.html
Look at the above link. Looks like orange is power (5v from ems module), blue is ground and green is the sensor output.
I hope this helps!
-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
I would like to thank everybody for the advice on this matter. Here is how I did it, works very good. (I changed de quick link for a new one.)
Thanks again.IMG-20160816-WA0002.jpg
IMG-20160816-WA0003.jpg