Maybe I'm missing something, but I don't see any instructions in the plans of what to do for access in the Horiz Stab where the struts attach. What did you do?
Thanks
Brian
Maybe I'm missing something, but I don't see any instructions in the plans of what to do for access in the Horiz Stab where the struts attach. What did you do?
Thanks
Brian
I believe its a SS7 you are working on? Page 26 of the fabric covering chapter.
Eddie
The Fabric Covering section for the horizontal stab of the build manual gives dimensions of a thin aluminum reinforcing plate that you make to glue on the inside of the fabric around the cutout for the strut attach area. I made the plates and installed them, but when I cut the fabric out of the middle I only cut about half of the plate opening. I thought the full cutout was way bigger than necessary. My smaller cutout has been satisfactory. I left it open. Most guys make a thin cover plate held on by small screws, but I just left mine open, sort of as a drain.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS