Hello all, was wondering If anyone had glued or put a pan head screw in the control grip to keep it from sliding up. Would hate for it to happen when a guy is pulling up on the stick.
Thanks
Patrick
series 6
getting ready for first flight
Hello all, was wondering If anyone had glued or put a pan head screw in the control grip to keep it from sliding up. Would hate for it to happen when a guy is pulling up on the stick.
Thanks
Patrick
series 6
getting ready for first flight
Go to the wifes side of the bathroom, grab her hairspray, slide the grip up about 2 inches, spray a little hairspray on it, slide it down and clean up after below the grip once its down
Chase
Model 5 OutBack
912 UL
Patrick,
What kind of grip do you have? I have a Ray Allen with the push to talk switch and I used silicone caulk to help keep it in place. After 100 hours now the grip is starting to move around on the stick so some other means might be better. I still want to remove the grip to access the switch. What are others using for this? By the way congrats on your nearly ready to fly Kitfox! It's been awesome for me to fly mine!
Dan
Dan G.
Model IV 1200 - Tri-gear
Jabiru 2200
Flying
Thanks for the tip Chase!
Dan G.
Model IV 1200 - Tri-gear
Jabiru 2200
Flying
You can still remove it after if needed, it doesnt permanently " glue" it and yer welcome Dan
PS that technic is for the foam grips
Chase
Model 5 OutBack
912 UL
Mine are a very tight fit; and also called for the installation on of one (1) simple aluminum pop rivet that you could drill out if you ever needed to change out the PTT switch, etc.
Grover Wright
Flying a KF IV-1200
ROTAX 912UL