Horizontal Stabiliser Trim

[Benbell4140]

Can anyone help me troubleshoot the wiring for the kitfox supplied trim indicator? I’m using dynon skyview. I found an old post that said to run the white wire to signal (pin4 on dynon ems) the blue wire to power, and the orange wire to ground. I have it hooked as stated but I get a red X over my trim display. Thanks!


Sent from my iPhone using Tapatalk

[P Johnson]

Can anyone help me troubleshoot the wiring for the kitfox supplied trim indicator? I’m using dynon skyview. I found an old post that said to run the white wire to signal (pin4 on dynon ems) the blue wire to power, and the orange wire to ground. I have it hooked as stated but I get a red X over my trim display. Thanks!


Sent from my iPhone using Tapatalk

Ben,

From the Skyview manual, remember it requires 5v, and you will have to configure which pin you have used in mapping.

Paul.

White / Blue	Black	Any of 3, 5, 13, 16, 17, 30	Ground It is acceptable to share this Ground with other sensors.
White / Orange	White/Red It is acceptable to share this pin / wire with other sensors; see Table 35 above.	18 It is acceptable to share this pin / wire with other sensors; see Table 35 above.	Power (+5V)
White / Green	Varies	Any of 4, 6, 7, 8, 9, 10, 11, 12, 20, 21, 22, 23, 31	Signal