If I were going to do that, I would just paint it. Either way, you're basically paying for your top coat twice.
If I were going to do that, I would just paint it. Either way, you're basically paying for your top coat twice.
--Brian
Flying - S7SS
Advantages of Oratex: does not require painting and lighter weight. Spraying a clear coat would negate both of those advantages. IMHO
By the way, I used straight edge tapes because the pinked edges are unnecessary (unless you are going for a vintage look) and I had observed that with no paint fill, they seemed to collect dust.
- Gary
S7 SuperSport Tri-gear
w/Rotax 912, Oratex, Dynon
At AirVenture this year, I stopped by the Orotex booth and looked the aircraft that were parked there to demonstrate their product. I also examined several other covering/finishing systems, even did about 8 hours at the Stewart Systems seminar in the Fun Zone.
The finish on the aircraft at the Orotex booth did not show their product in a good light. The finishing in the edges, cracks and corners of the surfaces looked rough. One aircraft had trim paint over some of the Orotex covering with some bleed through on the mask lines (especially at the tapes). The taping edges, as stated, looked sharp and a place for dirt/debris to collect.
Just my observations.
Ralph
If you want a show plane, don't use Oratex. If you want a light weight performer that looks great from 8' that you don't need to paint etc. use Oratex.
FYI I used urethane and being an amateur, my paint only looks good from 8 feet anyway. If I were to do it again. 100% oratex. Just my .02
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
if you have dust in your tape edges you aren't flying enough. That's how I will combat that issue.
Eddie Forward
Flying
SS7, 912iS, Garmin G3X
It’s probably actually as much or more of an issue with the white color that I used... most dirt & dust seems to be darker colored. That particular issue (dirt collecting on the edges of lap joints, finish tapes, etc.) can be mitigated with a good coat of wax. Makes it easier to blow off & clean too.
John Evens
Arvada, CO
Kitfox SS7 N27JE
EAA Lifetime
Chap. 43 honorary Lifetime
Oh and John made a show plane with oratex!!
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
I saw the Better Fabric/Oratex Tent as OSH as well. I later spoke with two different builders who covered with it. Both said the process was good. Both also said to make sure your initial order includes EVERYTHING you will need. Apparently the Supply Chain from Germany is very slow and frustrating if additional glue, fabric or other supplies are needed. One guy told me that there were some tense phone conversations with the supplier in Alaska; they hung up on him but always apologized later.
All things considered, I’m going with Oratex.