ADS-B (in) and Transponder Antennae

[fastfred]

does the dynon have the ads-b out built into it?

[N213RV]

does the dynon have the ads-b out built into it?

You need to have the Dynon transponder and the Dynon ADSB module. Both are remote units and the functionality is integrated into the SkyView display.

[aviator79]

You need to have the Dynon transponder and the Dynon ADSB module. Both are remote units and the functionality is integrated into the SkyView display.

To clarify, the most recent Dynon transponders are Mode-S with ADS-B out. So the "out" functionality is integrated with the transponder. To get ADS-B IN, you need an additional receiver that needs its own antenna.

[fastfred]

Can you list every thing we need to order to build this set up?

[jiott]

For Dynon ADS-B out:
-Dynon Mode S transponder
-Dynon SV-2020 GPS antenna puck

For Dynon ADS-B in:
-SV-ADSB-472 module
-A separate dedicated antenna (Dynon sells one; it is nearly identical to a transponder antenna)

All integrates with the Dynon Skyview panel.

[aviator79]

A Skyview display, two transponder antennae, coax and connectors, plus the following:

Disclaimer: You should call and discuss with Dynon. They'll ensure you get exactly what you need.

http://www.dynonavionics.com/mode-s-transponders.php

http://www.dynonavionics.com/adsb-du...ceiver-472.php

http://dynonstore.com/#!/SV-HARNESS-...egory=19307715

http://dynonstore.com/#!/SV-HARNESS-...egory=19307715

[fastfred]

So about$7000

[aviator79]

So about$7000

For a complete Dynon Skyview system, it will be more than that. You'd need ADAHRS, remote magnetometer, network cables, engine monitoring module, etc. If you already have a panel you like, Dynon probably isn't your best option for adding ADS-B. Their equipment is meant to run in its own ecosystem. Something like the Uavionix SkyBeacon would be a better bet. I believe they plan to add "In" functionality soon.

[Esser]

I bought a GTX327 with the plan to add a GDL88 later for ADSB requirements. About $4000 total with a used GTX327

[Maverick]

I am building a KF5. The location of the transponder antenna mount is just behind the passenger seat aft of the header tank. I am using the Garmin GTX327 and the echoUAT/skyFYX combo so, I appear to need a second antenna for the echoUAT. According to the installation manual I need to mount this second antenna 1 meter from the GTX327 transponder antenna on a ground plane that is at least 200mm in diameter. Has anyone else run into the issue of where to mount that second antenna? (pics would be appreciated)

Maverick