-Mike Kraus
RV-4 built and sold :-(
RV-10 built and flying
KitFox SS7 built and flying and now on amphib floats!
--Brian
Flying - S7SS
Can you list every thing we need to order to build this set up?
For Dynon ADS-B out:
-Dynon Mode S transponder
-Dynon SV-2020 GPS antenna puck
For Dynon ADS-B in:
-SV-ADSB-472 module
-A separate dedicated antenna (Dynon sells one; it is nearly identical to a transponder antenna)
All integrates with the Dynon Skyview panel.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
A Skyview display, two transponder antennae, coax and connectors, plus the following:
Disclaimer: You should call and discuss with Dynon. They'll ensure you get exactly what you need.
http://www.dynonavionics.com/mode-s-transponders.php
http://www.dynonavionics.com/adsb-du...ceiver-472.php
http://dynonstore.com/#!/SV-HARNESS-...egory=19307715
http://dynonstore.com/#!/SV-HARNESS-...egory=19307715
--Brian
Flying - S7SS
So about$7000
For a complete Dynon Skyview system, it will be more than that. You'd need ADAHRS, remote magnetometer, network cables, engine monitoring module, etc. If you already have a panel you like, Dynon probably isn't your best option for adding ADS-B. Their equipment is meant to run in its own ecosystem. Something like the Uavionix SkyBeacon would be a better bet. I believe they plan to add "In" functionality soon.
--Brian
Flying - S7SS
I bought a GTX327 with the plan to add a GDL88 later for ADSB requirements. About $4000 total with a used GTX327
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Here are some pic's of my installation for ADS-B in and ADS-B out. The small black antenna shown mounted by suction cup on the windshield is for the GDL-39 ADS-B in. The output is hard wired to a panel mounted Aera 500 and by bluetooth to a 8" Android tablet. Normally I use the tablet to display traffic from the GDL-39. The tablet also has the Garmin Pilot program to display other ads-b in data. The pic's of the interior looking AFT show the ELT mount and the ground plane for the ADS-B out antenna. ADS-B out is from the Dynon mode S transponder which is controlled by the Advanced 5600 EFIS. Also shown on the left looking aft and up the side of the plane is the Dynon mode S unit, also controlled by the 5600. The Dynon 2020 compliant GPS in mounted on the tubing above the pilot seat. Have about 50 hrs on the system and all is functioning perfectly. Note, the mode S antenna is a blade antenna as a stub (rod) antenna has marginal band width for Mode S.
Last edited by neville; 04-16-2018 at 06:37 PM.
I am building a KF5. The location of the transponder antenna mount is just behind the passenger seat aft of the header tank. I am using the Garmin GTX327 and the echoUAT/skyFYX combo so, I appear to need a second antenna for the echoUAT. According to the installation manual I need to mount this second antenna 1 meter from the GTX327 transponder antenna on a ground plane that is at least 200mm in diameter. Has anyone else run into the issue of where to mount that second antenna? (pics would be appreciated)
Maverick