Do you know what type of covering process was used? If it was polyfiber, and I had the plane, I would lift the edges of the finishing tape and clean it as good as I could and then reglue it with poly tac. Finish tapes are usually glued down with poly brush, but the tac should work good in this case. I have done that before and it worked fine. With all the colors right there, I would try to avoid pealing the tape off and putting a new one down. The tape isn't structural, all it does is double up the fabric to help whatever is under it to not chafe through the fabric. On the door, I would probably bend up some aluminum covers. Obviously the door rubs there, and the next fabric will get worn away also. Someone else just was posting about the SS covers they got from Kitfox. JImChuk