What prop are you running? Was it running fine before, and then this started happening by it's self, or did you do any adjusting or changes before this problem started to happen? JimChuk
I had this happen when I increased prop pitch. My theory was that the prop stalls at zero airspeed, then hooks up when you start to move, but because of the pitch bogs the motor. We're talking 1/2 degree of prop pitch did it. I was using a 68" three blade Warp taper.
I'm new to the Kitfox and 582's so I've taken a keen interest in learning why a problem like this can occur. What I've discovered is this problem (mysterious RPM decrease upon take-off roll) apparently manifests itself the same exact way but reportedly can happen for totally different reasons. One guy finds it's a prop problem, another finds out it's a faulty tachometer, yet another discovers some electrical issue with a coil, wire, plug or pick-up. Others report a good carb cleaning, rebuild or slight adjustment killed their Gremlin. One fellow reported a cable slack-adjustment issue to be the culprit. I thought I might even read where it happened to one guy on Tuesdays so he started flying on Wednesday.
From my research I've come to this one solid conclusion. If it happens to me I'm going to scream loudly OH CRAP among other things !!!
Be sure to let us know what you find.
I had the same situation as Guy Buchanan.
My IVO on my 582 was running fine, until I decided to add a bit more pitch one day when I had a long trip to do. There was an rpm drop on take off, enough to make me abort. I tried again and it did the same. I returned the pitch to what it was and it was then fine. I then added the pitch back and it did the same.
I got bored of fiddling so I just departed and did my trip.
One of my buddys had a similar problem with a 447. It was on the nose of a little plans built taildragger. After a good warmup he'd go full throttle and it would rev right up. I don't remember the static rpm but backoff and go full throttle the second time and it wouldn't go past about about 4000. Cut it off and let it sit a while, start it up and it would make good rpm. Back off and go full again and again it wouldn't go past about 4000. He's pretty experienced with Rotax engines and tried about everything and nothing worked. He had a spare 447 so he mounted it and fired it up. Guess what! Same result. It had a wood, fixed pitch prop that was supposed to be the correct pitch for a 447. For some reason it would rev up on the first rev but not after that. The only answer we could come up with was maybe the 447 lacked the torque to pull the prop through the midrange consistantly. Why it would rev up on the 1st pull but would not repeat is still a mystery. Anyway, a prop change took care of the problem. James Thomas
Did the prop move on its own slightly over time or were you making some adjustments when the rpm drop problem surfaced ?
My Kitfox had a 68" GSC when I purchased it also. It was already past the expected service life and I just didn't like the looks of its condition. After some research and talking to a few guys I went with the ground adjust IVO 72" medium 2-blade. Easy adjust, smooth and great performance.