All,

On our 2008 S7, the factory plastic lift strut fairings were installed on the lift struts. One of the four which was installed did not end up quite as straight as I would have wanted (as observed AFTER the hysol set up). It's not much, nobody else notices; but, you can guess the person who built it does. Given that these are bonded with hysol, what kind of challenges do you think I would encounter in removing one of the lift strut fairings to replace it with a new one? Also, the strut is not powdercoated; but, epoxy primed and finished with Aerothane.

Thanks,

Dave S