Quote Originally Posted by Flyboy66 View Post
This thread is a few years old and I will be picking my kit up the first week of June. My shopping cart is full of stuff that this forum has recommended, but no torque wrenches yet. What torque wrenches are people using for kit assembly (not engine stuff), and where can I get them?

I was going to get a 0 -300 inch lb dial, figuring that would cover most everything, and then borrow my neighbors Snap On clickers fit everything above that. What say the crowd?
FWIW from an anal engineer: I would suggest investing in your own torque wrenches. Wrench accuracy can vary widely depending on use and abuse. If you have your own, you can calibrate and use the same wrench every time. My Craftsman 3/8" and 1/2" clickers work fine.

Greg