Three coats of varnish seems like it is thin and will wear thru quickly. What did you cover the floor with?
Three coats of varnish seems like it is thin and will wear thru quickly. What did you cover the floor with?
Don't have a photo; but, am using rubber floor mats cut to size to cover the floor where feet go. Working on 6 years and this has protected the varnish - varnish still looks good as new.
Dave S
Steve Wilson
Huntsville, UT
Kitfox 85DD
912A / 3 Blade Taper Tip Warp Drive
Convertible Nosewheel & Tailwheel
SkySteve's SPOT Page
SkySteve's You Tube Videos
I use very thin sheet aluminum that is bonded to kraft paper (I believe it is used for heat duct manufacturing).
It slides neatly under the peddle mounting shaft and is held in place with 2 screws at the rear.
Very durable,economical,light,easy to replace and looks good.
Cheers
Don
Vixen C-FOXK 912UL
After bleeding the brakes, I was glad the original builder left mine varnished wood. Very easy to clean up.