I love this. I'm hoping to incorporate a set of amphibious floats onto our SS7 that we are building. For this reason, as well as a couple others, we are planning on the 914/Airmaster set-up.
Great work!
I love this. I'm hoping to incorporate a set of amphibious floats onto our SS7 that we are building. For this reason, as well as a couple others, we are planning on the 914/Airmaster set-up.
Great work!
Dustin
915is/AP430 powered Kitfox SS7
Enjoy the floats Mdock.
Love Kitfox on floats photos.
DesertFox4
Admin.
7 Super Sport912 ULS Tri-gear
to make a seal for the back of aerocets use an old inner tube slightly smaller diameter than what is on back of float. old bicycle tube is good.
stretch is over the fitting on the float and use some silicone in the inside and wrap in tight and use a tie wrap to get it snug.
I done this a few times and should last you a few years each time.
Also -- you can make the rudder a little bigger for more control.
Cheers.
Last edited by Dave F; 09-23-2013 at 04:48 PM.
Matt, Congrats on getting it flying with your float setup! Hope to see some good videos coming up.
-- Paul S
Model III SN910
582 IVO Med
Ok where is that dang LIKE button when ya need it
Looks great. I'm jealous.
Mike Bentley
Model IV-1200
Jabiru 2200A #438
Rotec Aerosport LCH Heads
Ellison EFS-2 Throttle Body
Prince Prop (64x34)
My SPOT Page
Sorry, I was otherwise occupied...here's the "like" button!image.jpg
Chris Holaday
Looking at the Model 5 or newer for size!
Lol thanks Chris! And that goes to both your ego's