-
Re: Kitfox on Floats
to make a seal for the back of aerocets use an old inner tube slightly smaller diameter than what is on back of float. old bicycle tube is good.
stretch is over the fitting on the float and use some silicone in the inside and wrap in tight and use a tie wrap to get it snug.
I done this a few times and should last you a few years each time.
Also -- you can make the rudder a little bigger for more control.
Cheers.
Last edited by Dave F; 09-23-2013 at 04:48 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules