So I’ve got the control column bracket assembled and I’m installing it but I have a question about position before I drill. I tend to look at something for a while before committing when locating something critical. I’ve positioned it in place on the center line on the bracket but I find that when it’s positioned in the place that measures out to be centered in the fuselage the holes are 1/16” towards the rear of the bracket. I measured from the horizontal support in the fuselage behind it and the distance to the column is equal on both ends. I also measured from the sides of the fuselage to the center of the pivot bolt for each control stick and they are equal as well. I’m just curious if any other builders have run into This?. I’ve attached photos and in the picture of the bottom of the bracket the top mark is the rear and is closer to the edge. Probably not a big deal but figured I’d check my work before drilling. Thanks IMG_2734.jpg IMG_2738.jpg