Same question I posted on Facebook.

Is the rear most elevator pushrod supposed to be bent? It's about 1.5 inches from being straight.
I purchased the KF a few months ago and build quality has been excellent.

The tube is clearly bent and is 3/4 OD, .035 ID, and 49" long. It's described in the build manual as part # 51041.106.

I tried to fit a 1" tube but a diagonal brace and the elevator trim actuator interferes.

279420278_5201918743162497_4492826567838039216_n.jpg279691485_5202080233146348_3591170837206493766_n.jpg