Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
If I recall they are in sealed electrically protected packaging and vertical power also shows online, I think, the installation of them.
Dustin Dickerson
Building 7ss STI x 2
Oratex
29" shock monster
EP912STI 155hp
Garmin
N33TF......FLYING!
N53TF......FLYING!
Here’s a good YouTube link.
https://youtu.be/bvDuyM2e4gw
Russ
Model IV Speedster
912UL IVO IFA
RV6A
Needle, Ball and Airspeed
Maybe a little GPS
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
FYI, Van's Aircraft parts catalog sell these diodes for the master and starter solenoids all ready to install with terminals attached and shrink tubed-no soldering or crimping required.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
Speaking of master solenoids: after beta testing, I just converted to a unit that B&C might start selling soon. It is a quarter pound lighter, draws only 329 mA, and has a built-in diode.
See my build log at:http://www.mykitlog.com/lowandslow/
Eric Page
Building: Kitfox 5 Safari | Rotax 912iS | Dynon HDX
Member: EAA Lifetime, AOPA, ALPA
ATP: AMEL | Comm: ASEL, Glider | ATCS: CTO
Map of Landings
Eric - I might; won't be able to check until maybe tomorrow - starting its first condition inspection - and will get back to you.
See my build log at:http://www.mykitlog.com/lowandslow/
Great, thanks!
Eric Page
Building: Kitfox 5 Safari | Rotax 912iS | Dynon HDX
Member: EAA Lifetime, AOPA, ALPA
ATP: AMEL | Comm: ASEL, Glider | ATCS: CTO
Map of Landings
Eric - better late than never; so saith he that has schedule control challenges. BTW - it does take a special but readily available connector. Recommend that if you do buy one of these, have the supplier source the connector too.
Close up.jpg
See my build log at:http://www.mykitlog.com/lowandslow/