-
Model 2 Elevator Weldment Twist
Hello everyone.
I have noticed on my Model 2 elevator weldment, during a recovering, that it has an offset (or twist) to it. The port side is slightly higher than the starboard side when on a flat surface. I wondered if it is supposed to be there? To reduce a tendency to flutter or counteract a right turning tendency or something like that.
I read online somewhere that the Model IV build manual stated there was a twist in the elevator on purpose and to not straighten it out. However, my Model 2 build manual does not state this.
Anyone have any good info on this?
Thanks!
Travis
Sent from my iPhone using Tapatalk
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules