This is a new thread that grew out of the Oil thermostat thread. I discovered a loose oil filter during the course of an oil change. It was so loose,that I could move it with my little finger !Fortunately ,I didn't loose any oil but I was about to ! During the prior oil change I had followed the instructions on torquing,leak checks,etc to the letter (I had the SI right in front of me) Having previously attended the Lockwood Rotax school and performing oil changes I asked specifically if the oil filter needed to be safetied and was told no.Well, I am here to tell you that they do.I called Lockwood after finding the loose filter and they told me that they had only heard of one other person discovering a loose filter during the normal oil change cycle.
Two other guys have reported loose filters just on the Oil Thermo thread (one engine ate itself due to loss of oil) so I know I am not one of two in the whole world to have discovered this. I made up a safety clamp with Adel clamp rubber under the clamp to mate against the oil filter. I then ran a safety wire to the engine so now the filter won't move (I also torque marked it)
If you have discovered this problem please call Lockwood,CPS,LEADING EDGE,etc and let them know so they can pass it on in their engine courses.
Dick