Pitch trim position sensor to G3X

[Michaels kitfox]

Yea it goes into the GEA-24. I wired it to the 244 connector on the GEA-24. You then go setup the input limits in the setup page of the G3X.

Red/Wht_Power pin 18
Blk/Wht_Ground Pin 20
White_Pin 19

Thank you Dustin. I wired up the sensor as you described into the GEA24B connector 244. That is the GP1 circuit in the G3X. I don’t understand how to configure the sensor to show a graph on the display. Any help would be greatly appreciated.
Michael