Just got home with the kit and am ready to start working. I read the Builders Tips section and now have some questions.

I am going to start with the horizontal stabilizer. The first page is reaming bushings and tabs. The Builders Tips, it says to put the shank through the bushing and attach the T handle, then ream the hole (helps keep the reamer centered). The tabs have two ears. Do I put the shank throgh both and then ream one hole, then back out the reamer and reverse it and do the other ear? Or can I just ream through both ears in one pass?

My concern is that by reaming both in one pass, I might cause one of the holes to be oversized. I have never needed to ream before and do not know if this is a concern.

Headed down to Home Depot to get a T handle and the auto parts store for the plugs to wash out the fuel tanks.

Steve