-
Axel wall thickness
Does anyone know the wall thickness of the 3/4" OD axels used on the Model III? I am actually looking for the ID, but will use any info that is available.
Thanks.
-
Senior Member
Re: Axel wall thickness
My from the factory Model IV came with solid axles. Drilling was an option, especially if mounting wheel pants. My current IV was started by a previous owner and the axles were drilled apparently for lightening as there were no wheel pants. The structural portion - where the bearings would be and about 2/3 of the length within the landing gear mounting tube is drilled to 29/64". Where the nut screws on and the last inch or so in the gear mount tubing are drilled to about a half inch.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules