New to the forum but I need a little help. I am rebuilding a kitfox 2 after it fell off a trailer and was drug on the asphalt a bit. I need to replace the bar on the top of the fuselage that connects the front side of the wings. Can some one with a kitfox2 share the measurements from lock-in pin to locking pin. I have to replace the entire rod due to damage and light rust, but want to make sure the wings are correct.
Also looking for a fox mentor in central Texas area.
I was going to say they should be the same dimention front to back, but just to be sure I ran out to the garage and measured my Kitfox 4 project. The 4 measured 36" center to center, front and back. I'm guessing the Kitfox 2 is the same. JImChuk