Thank you, so heat will help with bending.
Thank you, so heat will help with bending.
@ Mr Bill
To get the bend radius shown in my install, heating the line was required. Normally I would have routed the lines out of the valve straight back along the side longeron like Grover, then made a wide, lazy turn back forward to the spring gear fittings... but I was using what line on hand at the time and the goal was to git 'er done.
-Aeropro CZ Aerotrek A240 Tri-Gear SLSA 912uls
-Airdale Avid+ on CZAW Amphibs 'FatAvid Floater' (building)
-Kitfox 4-1200 TD 912ul (sold)
-Kitfox Model III TD 582 (R.I.P.)
-Avid Flyer Mk-IV TD (sold)