I didn't see any instructions on the seat pan storage cover. What is everyone doing, just cutting and setting it in place, or installing a hinge so it stays in place and does not move? Thanks
-Mike Kraus
I didn't see any instructions on the seat pan storage cover. What is everyone doing, just cutting and setting it in place, or installing a hinge so it stays in place and does not move? Thanks
-Mike Kraus
I have two. Both are a light sheet steel, both are hinged. One is held closed with a camlock, one is held closed with a keyed lock.
Steve Wilson
Huntsville, UT
Kitfox 85DD
912A / 3 Blade Taper Tip Warp Drive
Convertible Nosewheel & Tailwheel
SkySteve's SPOT Page
SkySteve's You Tube Videos
Clear acrylic sheet from Amazon, with a finger hole.
Doug
Super Sport
912ULS
Constant Speed IVOProp
Take a look at the link below...used angle aluminum around perimeter with piano hinge at rear of seat.
http://www.azshowersolutions.com/ToolBoxes.html
Dan B
Mesa, AZ
I used a light aluminum piano hinge on the rear and a finger hole on the front. Works fine.
Jim
Mine is attached to the bottom of the Seat Pad. When you pick up the Seat the lid comes with it. I believe it is Velcro'ed, it works great. I could go take a picture of it if you would like to see it.
Paul Zimmermann
LSRM-A
Garland, Texas