Oil cooler hole has been cut. Obviously will need to open it up, but these are the minimum cuts to allow the bottom cowl to fit in place. Top cowl actually fits pretty nice (without the windshield). I know the instructions indicate that you should have 5/8" clearance between the prop flange and the cowl all around the opening, but I may just leave the bad angle on the top cowl alone. I'll still have a good amount of clearance to the prop. Will definitely be making a custom glare shield at some point as the curve of the windshield will need to be very different to fit the new cowl.

IMG_0034a.jpg IMG_0035a.jpg IMG_0037a.jpg