Thanks, Bruce.
Steve Wilson
Huntsville, UT
Kitfox 85DD
912A / 3 Blade Taper Tip Warp Drive
Convertible Nosewheel & Tailwheel
SkySteve's SPOT Page
SkySteve's You Tube Videos
I run 8 to 10 lbs. More than that it bounces like crazy.
Mike Bentley
Model IV-1200
Jabiru 2200A #438
Rotec Aerosport LCH Heads
Ellison EFS-2 Throttle Body
Prince Prop (64x34)
My SPOT Page
Thanks Cubtractor. Sounds like a lot of 10 pounders out there.
Steve Wilson
Huntsville, UT
Kitfox 85DD
912A / 3 Blade Taper Tip Warp Drive
Convertible Nosewheel & Tailwheel
SkySteve's SPOT Page
SkySteve's You Tube Videos
I am running 15 psi on the Aero Classics with tubes. Don't notice any excessive bounce if I do a normal decent landing.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
You guys probably already figured this out, but I meant 21x8.00-6 tires...
I have a set of tubeless Grove wheels for my Mangy project and I'm planning to run the same tires there. I don't think I'll go less than 10 psi with that setup, either.
Are these the same tires you are talking about?
http://www.desser.com/store/products...NDRA-TIRE.html
If so I'd be interested to hear actual height and how they perform?
Sounds like my educated guess of starting at 25psi wasn't too far off. What do you guys think I should run with my 21" Nanco smoothies? 10psi?
Jay
yes, I've used that for years