-
Senior Member
Model II recommended main gear camber
Helping a friend set up his model II (oem bungee gear) and I notice quite a bit of positive camber (3 degrees each side) as it sits on the ground (kinda like an old Farmall Tractor). Rubber in contact with the surface is closer to each other (narrower stance) that the rubber on top (wider stance).
Is this typical? If so, what is a reasonable acceptable value? I was thinking the camber should be about zero or maybe slightly negative (similar to my High Wing gear).
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules