Here are some pic's of my installation for ADS-B in and ADS-B out. The small black antenna shown mounted by suction cup on the windshield is for the GDL-39 ADS-B in. The output is hard wired to a panel mounted Aera 500 and by bluetooth to a 8" Android tablet. Normally I use the tablet to display traffic from the GDL-39. The tablet also has the Garmin Pilot program to display other ads-b in data. The pic's of the interior looking AFT show the ELT mount and the ground plane for the ADS-B out antenna. ADS-B out is from the Dynon mode S transponder which is controlled by the Advanced 5600 EFIS. Also shown on the left looking aft and up the side of the plane is the Dynon mode S unit, also controlled by the 5600. The Dynon 2020 compliant GPS in mounted on the tubing above the pilot seat. Have about 50 hrs on the system and all is functioning perfectly. Note, the mode S antenna is a blade antenna as a stub (rod) antenna has marginal band width for Mode S.