To return or not to return

[Dorsal]

Looking for comments on the value of a fuel return line on a Rotax 912s. My understanding is that it allows more fuel flow through the line to help prevent vapor lock. Assuming one is burning 3-6 gal/hour how much more flow do you need?
All comments, controversy or suggestions appreciated.

[Slyfox]

I don't have a fuel return. I just put in a new motor, saw all the lines to put in and said, forget it, the other engine never had it. I did have some issues until I balanced the prop. Now the engine runs like a purring kitten. I don't have any firesleeve. I figure the engine area is running real low on temps, unlike a lycoming. This is a water cooled engine and the head temps are around 180 all the time, at least on mine. Firesleeve is an overkill in my opinion. What do I know, I only have about 1500 hrs on my fox. I will NOT put clear hose or bing blue hose in my engine area, it's all auto fuel injection hose. This stuff is real good and last a long time. My oil hoses are 1/2 300psi double braided hose, no firesleeve and doing great. I pull the cowls on a regular bases, about every 10hrs and do an inspection on everything, no problems.

[cap01]

red high temp rtv thinned with mek workes well also to seal up the ends of the fireseal

[akarmy]

For those thinking about a return line on the fuel system. I also did some research as to the fittings & restrictors needed. You can see the details on my site if needed. There's nothing amazing about it, just by the book rotax setup, just wasn't clear to me at first.

http://flying.karmy.com/?p=309

[Slyfox]

I was thinking of taking all my stuff and put it on, so my question, where do you put it into the header tank, could I just tee into one of the fuel lines going into the tank or do you go into the vent line up twards the top of the vent where there is no fuel.

I got all the necessary fitting for the engine side, just need to know where to put it into the header tank.

[akarmy]

Here's how the new header tanks do it. The fuel return is the top right hose fitting with the 90 elbow on it. Basically it just dumps the return into the top of the header. I would think that's very similar to using one of the vent lines.