1990 Kitfox with issues

[zadwit]

I have a 1990 Kitfox 2 with 700 hours on the airframe. The 582 was last overhauled by Rotax Rick and it quit running, stripped cross shaft drive gear. The airplane also had the gear knocked off sometime in* the past as there is evidence of wing tip repair and 2 flaperon wood tail ribs having repairs. I dont think any of the kitfox SB were ever done to this* plane . The fuel system has two small wing tanks that feed into a small aluminum "U" shapped header tank under the dash. When I removed this metal header tank I found red silicon sealant IN the OPUTLET FITTING!!!!! This is the same thing that killed that guy in a Vans RV that resulted in a big lawsuit....I found an electric pump installed and I think that is why. The is an electric pulse pump plumbed in parallel to the main vacuum pump which* seemed a bit odd and I can tell it was put on after the plane had flown some time. I dont have the logs but the seller found them and is flying them up* to me in a few days. I will end up rewiring the whole plane. The seat truss is "tweaked" a litte but not enough to replace it... The plane has the coil spring bungee cub type Vee cabane landing gear. I finally found out is it Kitfox factory bush gear beacuse the axles are matco bolt on axles so they can be shimmed. Ill enclose photos. I am mainly concerned on if I should effect a better repair on the tail ribs to the flaperon???? The broken tail rib part was glued on and then doublers added to each side. I have a copy of Kitfox SB #9 and could make the aluminum* repair parts...what do you think guysI bought a hydralic lift table from Harbor Freight Tools and used that to lift theplane by the front float fittings....The MLG photo shows the bolt on axles....tinhe wing spars are think .062 I think but have that riser milled inside. Photos of the lift table enclosed and a ISO metric drawing of a coil spring type shock stut. I know the shock strut* will work but I am going to weld up 2 new shock struts and wrap them with bungess. I am more familar with that and I am concerned that if the coil spring bottom out, the frame will get bent more. It is already tweaked a little bit...