Just curious it you primed your spars, if you did or didn't would be interesting to hear why.
Thanks
Brian
Just curious it you primed your spars, if you did or didn't would be interesting to hear why.
Thanks
Brian
Yes, inside and out.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Yup...inside and out over here. Overlapped on the epoxy varnish also.
Dave S
Kitfox 7 Trigear (Flying since 2009)
912ULS Warp Drive
St Paul, MN
Primed mine with PPG Epoxy Primer
Yes I used endura primer
Outside only
Mike
Primed inside and out. Living in California as you and I do, you will likely want to visit the coastline. Sprayed the outside and pored it into the inside with tennis balls to hold it in. I mixed up too much primer. One cup of mixed primer will do the job on one spar with plenty of left over. I mixed up about a half of a quart of primer then catalyst and reducer. Makes too much. Wasted plenty.
Eddie
Yes, inside and out.
NW Oregon is pretty wet.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS