VFR panel ideas ??

[Av8r3400]

My glare shield was trimmed flush to the panel, but I wanted an overhang. I used the same carpet as the rest of my interior, so I just cut it long and folded it over on itself to make the overhang.

It's flexible, yet rigid enough to hold its shape. About a 2" overhang. Seeing my Garmin GPS or the Dynon D180 has not been an issue.

[PapuaPilot]

I don't have any overhang. When the sun is overhead I put an auto windshield shade above my head to block out extra light. I am using one piece of the jumbo windshield covers from Walmart.

[Dave S]

Finishing the glareshield, decided on a flat gray lacquer finish on the fiberglass with a 1" overhang. The fiberglass edge has some potential for cuts and scrapes so decided to guard the lip by slitting a piece of vacuum hose and slipped that over the edge. Also installed the intensity adjustable red LED tape from Steinair behind the tube. (FYI The white interior light is on a separate switch.)

The lip protrusion with the tube is about 1 1/4" and have never had an issue with glare.

[N213RV]

Here is my panel..... Dynon SkyView, and a Garmin 696. Full 2020 ADSB in and out compliant, clean panel, and both have remote battery back up.

[ken nougaret]

Here is my panel..... Dynon SkyView, and a Garmin 696. Full 2020 ADSB in and out compliant, clean panel, and both have remote battery back up.

Now that's beautiful!

[efwd]

Yep, that is pretty. I just love those radios. The only reason I bought Garmin was to keep it all uniform. Those were what I really would have liked.
Eddie

[colospace]

Well, here is what I ended up doing. About 1-1/4" overhang. McMaster Carr edge trim. Six vent holes w/screens to let hot air out from behind panel. Black oxide stainless screws and washers (not screwed down in photo).
Paper labels are place holding until I receive the final placards.