Help needed with new Warp drive on my 582

[beeryboats]

I finally had a day to myself to hang the prop on my KF4 with a 582 blue head. In reading the instructions you can't miss the "MUST HAVE A FACEPLATE". I didn't recall a faceplate coming off, so I went to check on the old GSC woody to see if it was still on the old prop. No dice, it just mounted to the engine flange. In looking in the Leading Edge catalog I don't see a "faceplate" for sale.

So here I am, stuck. Has anyone else been here before?
Jay

edit: never mind, I found it in with the bolts.

[mr bill]

I think you only need a faceplate on a wood prop hub. With an aluminum hub it would not bee needed.

[beeryboats]

Ok, still need help. Was just starting to bolt the prop to the engine when I remembered the spinner cap. Ran home, down the driveway, and found the spinner has its own big thick plate. So do I use both plates, the spinner back plate on top of the steel one in the kit, or just use the plate from the spinner?

[Dave S]

Jim,

There are normally two applications requiring a crush plate (may also be called a "face plate"). Our plane has a Warp Tapered tip with HPL hub on the front of a 912ULS.

1) In the case of a wood prop - to disperse the torque of the bolts evenly over the prop head.

2) With a spinner bulkhead (and that depends on the specific spinner). For instance, we installed a UHS spinner with a fiberglass bulkhead which is designed to have a crush plate on top of the bulkhead to lend it stability and to disperse the torque over the bulkhead rather than concentrating the pressure right under the bolt heads. Attached photos of the UHS spinner/bulkhead which required a single crush plate on top of the bulkhead.

I can't imagine any situation where two crush plates would ever be needed. You may have a case where the prop supplier provided one and the spinner people provided one, each as an accessory to their product - possible duplication which beats not getting any from either!

The final authority would be prop and the spinner supplier - any doubts might be a good idea to call up both of them.

[ohlhausenr]

I just installed a three blade Warp Drive prop on my blue head 582 and ordered the Rotax face plate with the prop. Warp Drive recommend installing a Rotax face plate with their prop. Try www.warpdriveprops.com for info on the face plate. I ordered my prop from them and received good service.
Hope this will help you.

[beeryboats]

This is what we've always called a skull cap spinner. It does not cover the whole hub or have cut outs for the blades. It has a fairly thick base plate with a central stem that is threaded for a central screw from the spinner cap.

I assume the back plate for the spinner replaces the "face plate" called out in the prop instructions, but I'm not 100% sure.
Jay

[beeryboats]

Just found on Hover Hawk web site that the spinner back plate can be used as the face plate on Warp drive props. Just wasted an entire day on this issue. Wish they included instructions with the spinner....
Jay