Help needed with new Warp drive on my 582

[beeryboats]

GSC pitch is measured at 75% of the blade length. Warp drive degrees of pitch is measured at the tips of the blades. My 503 is set at 11.5 degrees at the tip, I suspect the 582 will need a little more than that.

FWIW, you're not the only one confused by the warp installation instructions. I installed my warp prop with the skull cap spinner 16 years ago and the instructions about the face plate confused me too.

Thanks Tom. I'm a little worried if I set it too low it may over rev the engine during break-in. Or if I set it too aggressive it may not rev enough to wear it in either.