How to build a Kentucky grass runway

[Bob Brocious]

Folks, I have a pasture where I've mowed a 1,400' runway. It has about a 4 degree down slope. I tend to take off downhill and land uphill unless the winds are really blowing.
It is rolling land with very little flat but it is fairly smooth. I have runway envy though and I see some of the places you all fly and I want to pretty mine up a bit.
I'm thinking that disking it a lot, then dragging it with a stretch of old chainlink fence and then seeding it. I'm just now sure what seed to use. Right now it's a mix of fescue, timothy, iron weed, white clover, butteryfly weed, bluegrass, etc.

Any experience in building a beautiful runway? Please post a picture or two as well. There's nothing prettier in my opinion, than a beautiful grass runway with a tail dragger sitting on it!

[3 tracks]

I just finished the ground work for my runway. It was recommended to me, by the local soils agency. To go on the MDT Aeronautics Division Website. Airstrip Turf Development. They recommend Sodar Streambank Wheatgrass or Sheep Fescue. MDT is the Montana Division of Transportation, these two seeds are what they use on there turf runways, With good results. I live in north central Idaho and we have similar climate. I went with Sodar streambank Wheatgrass ,after talking with Clearwater Seed they highly recommended it. There office is in Spokane WA. Ph 509 345 3108 Very helpful. They will ship seed to you.
Hope this helps. John

[Danzer1]

Soils vary quite a bit by region, as does what grows best based on climate. I'd talk to the local people at your U of K extension and maybe also have them do a soil test. Pretty simple process. Go here: http://extension.ca.uky.edu/county

Greg

[Bob Brocious]

I wonder how those grasses would handle the heat in Kentucky.

[Jfquebec]

Hi, for my runway (1800'x90') a Farmer with his big tractor plow and make two ditch in same time,after i work the earth with 39' rail from railway,i weld to Big chain on it i work with it at 45 degree, like that i fill a lot of big dépression.
After i put ''B'' mixture.. I wait one summer without cutting the grass.now i need to roll with heavy roller to remove all small bumb... Good luck

[Flybyjim]

I built a 100 by 1200 foot runway a few years back on my farm. The best advise I have for you is to take what ever time and labor you have and get it as smooth as possible. It took 3 of us 6 long days to move dirt, level, roll, stone rake and hand rake. After seeding we did not use it for 3 months. We seeded in early May here is Pa. The next year we rented a vibratory roller to smooth out the winters freeze and thaw. We still roll the airfield every spring with a field roller we made that we pull behind a tractor.
Good luck it's hard work but worth it in the end.

Jim

[Xengineguy]

About 8 years ago my father and I built my runway. I needed a large amount
Of fill dirt so I enlarged my pond using an old crane and large dump truck.
Once the fill was in place,we used two bulldozers to level it out. For final
Grade I built a pull behind grader of sorts. I used an old boat trailer,moved the
Axle all the way back,then mounted an adjustable 20"x8"x20' I beam.
I could adjust the front lip of the beam up and down to cut the humps
out as needed. Worked great. In this area we have clay and stones.
Mean stuff to do anything with! Also used the grader to push the stones to the sides for easier picking.
Took 3 to 4 years to get nice grass on it. Lots of work but worth it!