Flaperon support Inboard end - Mk3 Kitfox

[martinbguk]

Hi from the UK,
I have a question.
The two pieces of nylon? each side which support the inboard end of the flaperon pivot (one half in the turtle deck and one on the main fuselage).
I have to replace them for my next inspection as they are cracked.
Are they bought items or are they made to a drawing/pattern?
I've looked in the parts catalogue but can't find them.
If they are made parts, is there a drawing anyone can send to me (please )
Martin
G-BUOL

[jiott]

Just call Kitfox, they have them. I just bought some myself. They come in two halves that you need to cut down to the proper total width.

[martinbguk]

Thanks Jim
How much were they? in $ will do
Martin

[avidflyer]

The material is 1/4" UHMW.

[martinbguk]

Mine are way thinner than 1/4" probably 1/8"
They may have been incorrect from the start, or they may have been thickened up by Kitfox over the years I guess.

Mine are riveted in place, at 1/4" would bolting be better?

[jiott]

Forget what I said. I misunderstood the bearings you were talking about. The model 7 I built does not use those pieces.