A couple of series 7 tri-gear questions.

[Grant4ever]

Will a series 7 keep the nosewheel on the ground with the wings folded and roughly 400 pounds of weight/ballast in the cockpit?

If it will, is this a viable way to trailer the aircraft by strapping down all three wheels? I would REALLY like to bring home my new airplane while minimizing the possibility of damage to the rear fuselage.

I have used the search function and found nothing with reference to this. Lots of other ideas, tail stands etc.

[SkyPirate]

Youd be better off putting something under the tail where the tail spring would bolt on in my opinion, adding weight other then what the seat is designed for might not turn out so good

[SkyPirate]

How far have you got to go?

[SkyPirate]

when I bought my plane I put a deposit on it,..flew out with a friend,..inspected it,..called the bank and wired the remainder,..took 30 minutes for the wire,,then I flew it home

[Grant4ever]

Gotta go 1200 miles.

I've seen all the suggestions with reference to a support under the aft fuselage. I just figured that a couple of hundred pounds of sandbags in the pilots seats (that are designed to handle that weight) might allow it to sit on its nose gear and elliminate the need for a tail stand ( which is pretty tall on a tri-gear).

Can't/won't fly it home cause it's still in phase 1 and is currently out of Conditional and has sat for awhile. I'd rather get it home where I can go over it with a fine tooth comb and make sure it is good to go before continuing to fly off the hours.

[SkyPirate]

you could set the tail a bit lower with the support..as long as your under 13'6" on the trailer your good,.. going that far I know kitfox offeres a transit kit that supports the wings in fold position and a boot for the tail that the flaperons go up against when folded

[DesertFox4]

I think I've seen more tri-gears hauled with the tail down and the nose wheel off the trailer or on some of the converted light boat trailers the nose gear sticks out in mid-air.