Hello All
I have a new to me IV with quickbuild speedster wing. I have read many posts on this fine forum. Now before I get the drill out I have to ask for my own piece of mind. I have set dihedral to plans,wing twist to plans,triple checked with lasers,levels, strings and everything else I could think of. I checked plumb on tail in relation to fuselage. The tips are off when folded by 2.5 inches. I barely have 5 inch clearence at the HS on the low tip. So, am I correct in my thinking that most everyone believes that this is acceptable? I believe, just my observation, the fuselage wing strut attach point is not square to the rear spar attach point on the low side. So drill, or is there something I have not done correctly? Any info from you folks would sure be appreciated.

Thanks
Mike