Door prop rods

[Greensuiter86]

Does anyone have drawings or pics of gas strut installation for a KF II? I called the Kiftfox folks and the gentlman I spoke with seemed pretty uninterested in even talking about the older models. I've read some discussion in this forum, but didn't see any pics or specs. Seems this would be a pretty easy and straight forward install.

Thanks,
Jay

N627C
KFII/582

[Kurt.A]

You bet Jay. I will take some pics of mine tomorrow in the day light.

[Av8r_Sed]

Here's a pic of my cylinder installation. Extra points for the in-flight photo?

[Greensuiter86]

Thanks Av8r...you must live on this forum The finish on your bird looks awsome as well. Did you get the struts from Kitfox and are they 40#? I know they have struts listed for models 1,2,3, but the gentleman I spoke with said he had negative knowlledge if the mounting hardware for the model IV would work for a II... Easy enough for me to fab some brackets and rivet them on, I'm just a bit apprehensive to drill into the airframe down tube and rivet...

[Av8r_Sed]

I don't recall the pound rating on mine. One of my building partners obtained them. One mounting bracket was cut down from a factory part. The other was fabricated from angle. We did use structural adhesive and flox fillets to support their installation on the tubes and dipped the rivets in structural epoxy to help solidify them.

[Greensuiter86]

Found a pair of C16-10788's and 10mm ball studs at a local Truck cap dealer (side glass prop rods) and will be doing an install this weekend! Thanks for the info Jay!...and all that responded...you guys are awsome, I'm loving this forum already and intend to contribute whenever I can

[jdmcbean]

Thanks Av8r...you must live on this forum...

It would appear that the same install kit for the IV would work on the 2 as well... Let us know if we can help..

[Greensuiter86]

Thanks John, I'll be getting with you folks in the near future for some other items.

Regards,
Jay

N627C
KF II/582