Trim motor

[Jim]

I have a series 5 with the electric trim on the stabilizer. I adjust it as per the manual. It always goes up full stroke. I can not get it to stop at the required clearance. Any thoughts? Jim
jezim@pro-ns.net

[SWeidemann]

Jim,

I will be watching your replies, as I have a Model 5 Vixen and a new trim motor/jack screw in hand to install with not much documentation.

Skot

[jiott]

I have a series 7 but I think they are the same. The ballscrew always goes full stroke, but by adjusting the stem per the manual it will stop on the upper end where you want it to. You set the upper limit and the lower limit is not separately adjustable.

[Jim]

My problem is with the up travel. I set it per the manual, run it down & when I run it up it goes full stroke. I can't adjust it the stop short. It always goes until it hits the tubing. Thanks for your input. Jim

[jiott]

Do you have the stabilizer installed and all the little links?

[kitfox2009]

Hi Jim
Have you checked your wiring or possibly the switch? It should stop immediately when you release the rocker switch to neutral.
A few years ago the switch stuck at full down (I believe we had something jammed on the switch when flying- Two guys winter gear)
Anyway it ran to full stop and then burned out the motor. Still flyable but heavy controls.
Take care
Don

[Jim]

Do you have the stabilizer installed and all the little links?

Every thing is as the plans show.