Kitfox tailwheel spring 3 leaf

[Jerrytex]

Just got my new 3 leaf tailwheel spring from Kitfox. Noticed that it is plain bare steel. Kind of thought it would have been painted or something but it's not. Anyway, just wondering what the consensus is as far as treating the spring? Thinking about using a good etching primer and then some rattle can industral enamel? Any other ideas?

[akarmy]

Thinking about using a good etching primer and then some rattle can industral enamel? Any other ideas?

I used POR15 which is a super tough rust proof paint / primer system. It has held up very well over the years.

[kitfox5v]

Andy, I like that tail wheel. What kind is it? Thanks Eddie

[akarmy]

AlaskaBushwheels 3200. Got it from John at Kitfox Aircraft.

http://www.akbushwheel.com/index.php...d=61&Itemid=83

[kitfox5v]

Its no wonder it looks so good. Has a good price with it too. Thanks for the reply. That will have to go on my wish list. Eddie

[akarmy]

Its no wonder it looks so good. Has a good price with it too. Thanks for the reply. That will have to go on my wish list. Eddie

I could sell you a nice Matco 8" pneumatic for $150 if you like.

http://www.matcomfg.com/TAILWHEEL8PNEU-idv-2678-69.html

[Jerrytex]

I like that POR-15. Says you have to paint over it if exposed to UV. What kind of paint did you paint over it with?

[SkyPirate]

that is sweet Andy,..nice job

[akarmy]

I like that POR-15. Says you have to paint over it if exposed to UV. What kind of paint did you paint over it with?

None, I only fly at night when there's no UV...

So far it's been fine without a top coat, not sure what will happen in 10 years, but we will see.

[kitfox5v]

Andy, Sent you a PM about tail wheel. Eddie