Teflon sheets for smoothing finishing tapes

[phintz]

You can try this also if you'd like. Wax paper!! It transfers heat great without the polyspray mess on your iron. It worked great for me, hope this helps another builder!

[SkyPirate]

Ive done the wax paper too works pretty good

[kmach]

Has anyone every tried using parchment paper that is used for baking ?

I have not tried it , but I think it should work.

[mr bill]

I wish I had known about the use of Teflon sheets in time. I used Stewart Systems adhesive and it was annoying to have to clean the iron periodically. Looking at the pictures, it appears the tapes would have laid a little smoother. Not a big deal, but it would have been nice. By the way, my $15 Monokote iron worked better than my $50 Coverite iron.

[n85ae]

For tapes I used a Monokote iron with nothing else (i.e. no sheets, etc.), and
had no troubles at all. I use the Polyfiber system. It's all about heat, timing,
and technique. A quick swipe across a rag usually gets most of the Polybrush
residue off the iron.

Regards,
Jeff

[avidflyer]

I have some clear plastic that came on a large 4' wide roll. It is probably about 6 mill for thickness and it's kind of stiff. A friend of mine gave me some of it and it works quite well for this job. I have 3 or 4 pieces cut about 6"x24" I use them one after the other, as sometimes the polybrush would stick and start to lift if it was still hot enough to melt to the plastic. By the time I iron down the fourth one, the first one is cold and pops right off the polybrush even if it stuck to the plastic a bit. I've even used it some with the polyspray if need be. It did kind of melt things and leave them somewhat as smooth as the plastic if there was enough material there, but the next coat covers it and the shiny surface goes away. This plastic stuff really helped to keep stubborn pinked edges down. I might have some pics, but they would be in my old PC which is not set up now. Jim Chuk

[Alexsandro111]

Great, very detailed and understandable manual - also with illustrations

[taff]

I suggest you click on the manual and go to chapter 8, for more info on PolySpray

https://4dc8cf9a-0bab-40d5-bd6e-ca9b...2c97c69571.pdf