Any suggestions on how to stop blow by at the slip joints on the exhaust on the rotax 582. The oily mess is is horrible
Any suggestions on how to stop blow by at the slip joints on the exhaust on the rotax 582. The oily mess is is horrible
It takes a little time but works. I used valve grinding compound from NAPA. Just spread it on the two halves and work it around. I think it took me about two hours. No issues since.
Pieter
Pieter
Kitox IV 1050
582 70" IVO IFA
Yup, lapping compound, elbow grease and lots of patience. I spent more than two hours and only got it to good enough. Once you've got them lapped in don't forget to apply a tiny amount of anti-seize to the joints to keep them from freezing up.
-- Paul S
Model III SN910
582 IVO Med