All,
I'm preparing my lift struts for assembling by mounting fairings onto them.
My wings are in a hangar some miles away, the fuselage is in the shop near my house. Now when I assemble the whole lot it has to be right in one shot: there is no room in that hangar to leave the plane with wings-open.
Therefore I want to make the 'cut-away's' on the backside of the fairings (needed because otherwise the fairing will enter the fuselage when folding the wings, in an unpleasant way) before I assemble - without having a wing to fit if the cut-away is away enough - or too much..
Is it possible for you guys to help me with this one , again, by measuring the length of the cut-away from the attach-bolt to the end of the cut-away?
I would be very helped!
Tx in advance,