Tom,
If it is not too much trouble, I would like to see a picture of the "finished product..."
It would also put the "finishing touch" on this part of the thread. THANK YOU! Grover
Tom,
If it is not too much trouble, I would like to see a picture of the "finished product..."
It would also put the "finishing touch" on this part of the thread. THANK YOU! Grover
Here's how I've done some:
First, I cover the inside with fabric, then install it on the fuselage.
Next, I bond two small aluminum strips at either end of the butt rib to attach fabric to.
Lastly, I cover around the square door tube and under the butt rib.
Notice earlier builds had the cap strip facing inward, now it faces outward.
Mark & Renee Smith
Boise, ID
"Build It ..."
I added the finished photos to my post above. It's post #9
Last edited by t j; 01-22-2013 at 02:39 PM.
Tom Jones
Classic 4 builder
Did mine with glasscloth/epoxy for the rib, and aluminum under. I also glued
in Lexan viewports to see the sight tubes:
Jeff